LooserLu
LooserLu
Hi
tomorrow, we’re going to repair a leaky mast tube. It’s a hull built in 1981. So, it has no stainless steel “anti wear plate” inside of the mast step. We’re going to install such a disk, too. To this I have a question:
How much is the MINIMUM length of the distance “d” (view sketch in attachment, below) to be on the save side of the class rules?
“d” goes from the upper side of the deck to the upper surface to the with epoxy resin installed new stainless steel disk.
Thanks for your infos to this question.
LooserLu
tomorrow, we’re going to repair a leaky mast tube. It’s a hull built in 1981. So, it has no stainless steel “anti wear plate” inside of the mast step. We’re going to install such a disk, too. To this I have a question:
How much is the MINIMUM length of the distance “d” (view sketch in attachment, below) to be on the save side of the class rules?
“d” goes from the upper side of the deck to the upper surface to the with epoxy resin installed new stainless steel disk.
Thanks for your infos to this question.
LooserLu