Aquaman's advice is correct. The 14.2 owner's manual provides a diagram for placement of reefing grommets and tie down grommets but what is more important is adding reinforcing sail material to the main at the reefing point locations; to handle the stress on the sail material and control...
None of the 14.2 s were designed for flooding the bilge. So, probably, any stringers are not resin impregnated or sealed, none of the under deck areas are totally sealed compartments and probably have weep holes etc so that any condensation or eventual leakage from external fittings (which may...
My 2015 14.2K's gunwales are just wide enough and roll over and clear the hull enough so that I was able to mount 4 or 5 inch marelon hollow base cleats just forward of the location of the holes for the traveler line. The underside of the overhang has a curvature of course and I was able to fit...
Aquaman has some extensive site posts regarding boat upgrades and there are others as well. I sail a 2015 Mod3K which I keep moored at my dock during the sailing season. The boat has a factory mounted motor mount and I added a boarding ladder. For a "kicker" I use a Honda 2.3 hp outboard and...
I think we would be on the same "page". I have posted before about sailing a Tanzer 16 (center board) Tanzer 22 and then a Cape Dory Typhoon (keel boats) which I restored. Now after eight or so years of sailing a 14.2K and hitting 77 years, I really appreciate the simplicity and performance of...
Older model 14.2s, before Mod 3 I think, did not have hull and deck joints sealed or glued together as well as they should have. So, you may need to seal obvious separations with a product such as 3M 5200 or 4200. For good and detailed instructions/suggestions regarding fiberglass repair I have...
Great reply from LaLi and Kerrcat has no pride of authorship, so anyone should jump in.
The 14.2 has so many other ways to adjust the main without having an adjustable traveler. The first control is let out the sheet, and for me the second control is often adjusting the boom vang tension or...
Yesterday's conditions were winds 6 to 9 with gusts generally up to about 15, maybe a few higher than that. Wind was blowing across the lake so there was not a lot of fetch and not quite white capping. With the keel boat and single handing I never felt the need to hike out on the gunnel or...
Not sure. It is possibly an epoxy barrier coat, which is applied to seal the gel coat to protect from gel coat blistering in preparation for coating the bottom with a good bottom paint. Because my 2016 14.2K is kept in the water (freshwater lake) all season it was prepped when new with the...
Short answer is probably yes. The keel version draws about two feet, adds two hundred pounds of ballast, and eliminates having a centerboard well; the cockpit is self draining. My boat was built in 2015 and I ordered it with a factory mounted motor mount, topping lift, and installed lazy jacks...
https://sailingforums.com/C14_Handbook.pdf See this site for class information, rigging specs, and a Quantum article on how to sail the boat. Also, North Sails has a tuning guide for the C14.2 online, somewhere. And, UCLA Sailing School's old basic course handbook uses the Capri14.2 for...
Glad the info was useful. Always be sure to give Catalina Direct your hull number when ordering "stuff" so they can match up the correct rigging etc. Usually their descriptions include info regarding which versions/models of the 14.2 changed rigging etc. My 14.2K was built to order in the summer...
Correction. Second sentence should have been "That pennant attaches to the mast."
Not sure about earlier furling systems but the current Selden rig (Mod 3 - 2016 model) does not use any stay adjusters to adjust mast rake etc. I added a jaw toggle to the furling pennant which effectively...
You should have a jib pennant which is about one foot three inches long attached to the top of the roller furling jib. That pennant attaches to the main. Attach the shrouds and then raise the mast with the pennant and jib attached, attach the roller furler drum to the fitting on the bow; just as...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.